Cutting Board Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bracket stand that holds a thick end-grain cutting board upright on the counter to air-dry or display.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 71
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
A bracket stand that holds a thick end-grain cutting board upright on the counter, instead of lying flat where moisture gets trapped underneath.
What you get
Two-pillar cradle with a taller rear pillar, so the board leans back at a stable angle
Notched pillars cradle the board's bottom edge so it cannot slide off
Triangulated open base keeps the print light while still resisting tipping
Base 160.1 x 78.8 mm, 115.7 mm tall at the rear pillar
One printed part, no fasteners
Fit check
Boards around 30 mm thick (tested at 32 mm)
Any board light enough for PLA to carry — tested with a real end-grain board, see the photos
Set it on a flat, dry counter
Print settings
Bambu Lab P1S, stock 0.20mm Standard profile.
PLA (Bambu PLA Matte on the test print)
0.20 mm layers / 2 walls / 15% infill / no supports
Fits a 256 x 256 mm bed; Bambu Studio project file included
Support me
If this design was useful to you, you can buy me a coffee ☕
Need a different size?
STEP file is included, so you can adjust the notch depth for a different board thickness. The full Onshape source is public too: Onshape document
LICENSE: CC BY-NC