1 / 5
Samsung Oven Knob Reinforcement Sleeve (DG94-03500A Compatible) — zdjęcie 1
1 / 5

Samsung Oven Knob Reinforcement Sleeve (DG94-03500A Compatible)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Prevent cracks or reinforce cracked and even broken hubs on Samsung oven knobs.

Ocena
0 / 5
Polubienia
0
Pobrania
5
Wydruki
0
Wyświetlenia
32
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution

If you own a Samsung range with these knobs, you've probably already experienced the failure, or eventually will.

The plastic hub inside the knob that interfaces with the metal control shaft develops cracks over time from repeated use and heat cycling. Once the hub cracks, the knob begins slipping, becomes difficult to operate, or eventually fails completely.

This sleeve was designed to reinforce that weak point before failure occurs and can also help stabilize knobs that have already begun cracking. One of mine the side completely broke out, I glued and put this over it and it works great now.

The sleeve fits over the plastic hub inside the knob and distributes the load more evenly around the shaft interface, reducing stress on the original plastic.

Features

  • Reinforces the factory plastic hub

  • Helps prevent common knob cracking failures

  • Can be used proactively on undamaged knobs

  • May extend the life of already cracked knobs

  • Quick print with minimal material

  • No hardware required

Print Settings

Recommended

  • Material: PETG

  • Layer Height: 0.20 mm

  • Infill: 30%

  • Walls: 4+

  • Supports: None

  • Brim: Not Required

Tested Print

  • PETG

  • 0.15 mm layer height

  • 30% infill

A larger layer height should work perfectly fine since dimensional accuracy is not especially critical for this part.

Tagi