Ioniq 5 adaptable Phone/Bin Cup-Holder Add-On
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An adaptable holder for one or two phones that clips into the cup holders of a Hyundai Ioniq 5
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Like Vegar, whose model this is a remix of, I got tired of my phone occupying the cup holder.
But it blocked the release catch that allows the console to slide back & forth. So I remixed the original with a gap so that you can access it.
Also, like slic0r who did an earlier remix, I was mildly irritated about my phone always falling over.
However, including a permanent holder would obstruct the gap for the console release, defeating the original point of the remix. So I designed a removable insert to do the job.
It is, in fact, possible to operate the release catch with the phone insert in. Just.
I designed two holders - left and right - as the left one needs to be smaller to allow for the cable clip.
I've printed and tested it in PETG rather than PLA to better withstand the ever-hotter summers in the UK.
So far, so not-melty. Which is more than I can say for the poor Jelly Baby that got welded into the bottom of it.