Mini Hand Powered Shredder *READ DESCRIPTION*
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small prototype shredder that is probably ready to tear things apart.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 108
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
This is a prototype model that I am pretty sure will work but has not been tested. If you do print it leave a comment and a make describing what could be better, what is good, and whatever else you have to say.
Uses very little amount of supports. Would recommend 60% gyroid infill. Any printer should be able to handle the tolerances.
You can use the handle that is there for you or you can use a US 5/8 wrench or a metric 16 wrench.
No remix culture yet because this is a prototype and needs to be tested and verified that it works well before I let people remix it.
Instructions:

Glue the shaft to gear 1. Do the same with the second shaft and gear 3.

2. Make sure you put everything together in the same orientation as it is in the picture. Before you continue, look at the picture below to see how the shredder gears should be positioned. This has to be perfect unless you want your shredder to shred really weird and less effectively. You could change it if you want, but it won’t work as good. You can make all the teeth close at one time by only printing one kind of shredder gear, but as I said, it won’t work as good. The closest 2 shredder gears in the picture would be the ones closest to gear 1 and gear 3.
Start pushing the shaft connected to gear 1 through the main part. The shaft will go through the first hole in the main part then through a shredder gear 1 with a bead then through the main part then through a shredder gear 2 with a bead then through the main part then through a shredder gear 1 with a bead then through the main part then through a shredder gear 2 with a bead then through the main part then through a gear 2 at the end then through the main part again. When you get the shaft out the other end push it all the way through. Repeat with the shaft glued to gear 3.


Put main part 2 in place then use slide connectors to keep it in place.

(If you’re using a wrench skip this step) The handle slides together as shown.