The Double-Double - a 5-Geared Spinner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
2 gears on each side, that's why it's the Double-Double.
- Ocena
- 4 / 5
- Polubienia
- 8
- Pobrania
- 21
- Wydruki
- 1
- Wyświetlenia
- 236
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Model published 05/08/2026
Changelog 13/08/2026:
Added updated GIF.
Changelog 13/08/2026:
Added proper headings.
Another contest entry, I needed an actual spinner this time. Since normal geared spinners with 1 layer of gears surrounding it are pretty common, I decided to do something else. ;)
Print Settings:
Print 4 gears, one A frame, one B frame, one axle, one central gear, and 2 caps.
Layer height: 0.2 mm or less
Supports: Yes (on the B frame only)
Brim: If needed
Assembly:
Place each gear onto the axles (excluding center gear and center axle).
Assemble the frame similarly to the OG model, just multiplied.
Push in the central gear from the side like this. Make sure it's aligned.
Push in the central axle from the top, then attach the caps on either side. You may need an adhesive for the caps. The central gear is the one that is tight, and won't spin. If it spins slightly, add a layer of tape on the central axle.
General Troubleshooting
Problem | Cause | Solution |
|---|---|---|
Gears not rotating | Unclean gear, seam line inside | Use an appropriately sized drill bit to smoothen out the inside, or add a small amount of lubricant |
Tight/loose assembly | Low tolerances, rough print lines | Adjust tolerances by scaling - if too tight/+ if too loose, sand down rough lines |
Parts warping/removing from bed | Dirty print surface, too little adhesion | Spread an even amount of glue stick on the bed, add a brim/raft |
Happy printing!
-X3