Creality K1 & K1C Additional Adaptor and Bend for 32mm ducting
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy to print no support required
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 80
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made these as i have been printing a lot of ASA and wanted to vent most of the fumes to the nearby window. This was the best solution for my set up using the original design as a starting point.
Slip on filter adaptor down to u bend. Designed as 2 separate parts to allow printing with no supports. this also gives you options depending on where you want to duct the air too.
The adaptor should be printed on the small end with no supports. It just slips over the original hepa+carbon filter housing.
The U bend then slips over the 32mm ID nozzle and tapers down to 32mm OD to allow a standard 32mm duct you can get from most hardware shops. Bend should be printed on the flat section. The flat section also allows you to move the printer back as far as possible if its up against a wall.
If you want to just vent straight out the back don't print the u bend section. The U bend is intended to get you around to the side of the printer so you don't need to bend the 32mm pipe.
You may require a few jubilee clip to keep the 32mm pipe on.
This was all printed and test fit using a 0.6 nozzle and 0.3 layer height so you may need to scale down a tiny amount to get fitment perfect on a 0.4 nozzle.