1 / 5
Baroque Pearl Hoop Earring — Print-in-Place Sliding Pearls — zdjęcie 1
1 / 5

Baroque Pearl Hoop Earring — Print-in-Place Sliding Pearls

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A hoop earring strung with six irregular baroque pearls that really slide around it — printed in one piece, no assembly,

Ocena
0 / 5
Polubienia
0
Pobrania
0
Wydruki
0
Wyświetlenia
19
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

A pearl hoop where the pearls actually slide - and it comes off the plate in one piece. Six irregular baroque pearls, each free to travel about 19 mm of bare rail. No jump rings, no glue, no assembly: the capture is printed.

The trick: the hoop is a MONORAIL, not a round wire. A bead captive on round wire cannot be printed flat - the bead's bore IS the print clearance, so whatever gap lets it move also lets the wire back out, and real capture would need a negative gap (a weld). So the rail is a T-section instead: a 2.2 mm bulb carried on a 1.0 mm fin down to the bed. Each pearl is a keyhole saddle - a 3.2 mm cavity around the bulb, opening through a 2.0 mm slot that the 2.2 mm bulb cannot pass. 0.20 mm of interlock: captive, but free to run.

Printed flat, the fin and the pearls' slots both face backward when worn, so from the front it reads as a plain pearl hoop - the fin just shows as a fine second line inside the ring.

Optional two-colour, no extra work. The STL is seven separate shells (rail + six pearls). In Bambu Studio: Import, right-click, Split to Parts, then assign the rail one filament and the pearls another. The photos are a yellow rail with pearl-white pearls done exactly this way. Single-colour prints fine too.

Print notes:

  • About 33.6 x 33.7 x 7.0 mm, roughly 1.8 g - a few grams for the pair.

  • Prints flat on the bed, no supports, no brim. 0.2 mm layers.

  • Any filament. PLA is fine, PETG gives a slightly slicker slide.

  • Print two for a pair. Pass -D seed_base=1234 to the .scad for a non-identical twin: the pearls are deterministic from the seed, so the second hoop gets its own irregular blobs instead of being a clone.

  • If a pearl starts stiff, twist it once around the rail and it frees immediately.

  • Bail hole is 2.4 mm, sized for a standard jump ring and ear wire.

Fully parametric OpenSCAD, source attached. hoop_r resizes the ring, n_pearl sets the count (six is the practical maximum - seven forces the pearls small enough that the build plate slices them above the equator and the bed-cut edge droops), pearl_dmin and pearl_dmax set the blob range.

Tagi