1 / 4
Nikon FM, FE, FM2, FE2 Battery Holder Repair Part — zdjęcie 1
1 / 4

Nikon FM, FE, FM2, FE2 Battery Holder Repair Part

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a part I designed to replace the commonly broken battery case inside the Nikon FM, FE, FE2 and FM2 cameras.

Ocena
0 / 5
Polubienia
0
Pobrania
27
Wydruki
0
Wyświetlenia
115
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

This version allows you to break the rivet and electrical contact out of the top of the broken battery case and then insert it from the side as a unit. That way you don't need to redo the rivet. The hole in the side will allow the rivet shaft to snap into place without glue. 

Trimming off the features to hold the motor drive springs should allow you to use this part inside a Nikon FE2, FM2 or FM2n although I have not tested those bodies. 

I have paid to have them professionally printed in sintered Nylon 12 and dyed black. They were much stronger than needed so should last many years. I like to add a small piece of tape across the contact on top of the case so if the case moves and changes shape some over the years, it will not short out to the camera metal chassis. Shown in the last photo. 

I've installed these in 4 Nikon FM cameras I've repaired as of this upload.