1 / 3
Renson Ventilation Grille Rod Clip (Hendel) - Replacement — zdjęcie 1
1 / 3

Renson Ventilation Grille Rod Clip (Hendel) - Replacement

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Renson Hendel - Replacement Rod Clip for Ventilation Grille Control Rod (Hendel 50mm)

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
29
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Public Domain

Replacement clip for the control rod of a Renson trickle vent / ventilation grille (Dutch: stangclip/hendel for a ventilatierooster). The clip grips the rod and plugs into the handle of the grille, so you can open and close a high-mounted vent from floor level.

Mine snapped off after years of use and the part doesn't seem to be sold separately, so I reverse-engineered it from the broken original.

Fits

Matches the Renson Hendel 50mm (EAN 8718734113683).

Dimensions

  • Overall: 9.8 × 47.9 × 11.65 mm

  • Rod bore: ⌀5.94 mm, outer boss ⌀9.75 mm

  • Blade: 3.6 mm wide, with retaining lugs at 34.4–36.6 mm

How it was made

The original was scanned flat at 600 dpi. I traced the silhouette from the pixel grid (no ruler scaling needed; 600 dpi is 23.62 px/mm), fitted the boss and bore as least-squares circles, and extruded the profile by the measured 11.65 mm thickness.

Print settings

  • PETG or ASA. Not PLA. It creeps under the constant load of the snap fit and gets brittle in a cold window reveal.

  • Flat on the bed, 3+ perimeters, 40–60% infill.

  • No supports needed.

Known limitations — please read

  • I thickened both prongs by 0.5 mm on the inner faces to get three perimeters instead of two. This narrows the slot between them from 1.62 to 0.62 mm, which reduces flex travel. Check the slot width in your grille's handle before printing.

Tagi