1 / 8
2006 Pleasure Way RV - Replacement Battery Door — zdjęcie 1
1 / 8

2006 Pleasure Way RV - Replacement Battery Door

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a replacement battery door for a 2006 Pleasure Way RV

Ocena
0 / 5
Polubienia
1
Pobrania
0
Wydruki
0
Wyświetlenia
21
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A family member has a 2006 Pleasure Way RV. On one their recent travel adventures they lost the door off their external battery compartment. The replacement part is close to $1,000 Cdn (unpainted) and then they would have had to have gotten the part painted.

They wanted a simple utility door ensuring the battery was protected and they were not concerned about an exact replacement. In hindsight I could have traced out the bottom trim feature, but I was more concerned about getting the battery compartment protected so they could get back out on the road and not worry about losing their battery. 

The panel is too big to print in one go so I split it in two, used connectors and JBWeld to glue it together. The other thing I did was add a piece to the back with 10 magnets that latches onto the battery tray. The door is secured to the RV using stainless steel screws through the existing piano hinge. We went with  1 inch screws thus ensuring they would only lose the door through catastrophic failure. It also has a Cam lock to secure it in place/lock it shut. The piano hinge was a bit of an adventure because you would think it would be symmetrical. It is not.

I printed the part in PETG (what I have on hand), but that's just the core. It was glued together with JB plastic weld, Bondo was used to smooth out the part. It then had multiple coats of automotive primer, then colour matched paint and then a couple of coats of clear coat. Basically the sort of steps you go through when doing automotive repair. I was very new to this step but muddled my way through. 

Filament: Elegoo Rapid PETG, 40% gyroid infill, 5 to 6 perimeters.

The model itself is available on tinkercad: https://www.tinkercad.com/things/eXlbou2TK5P-2006-pleasure-way-battery-door

I've included the project file (3MF) and the STL files in case you want to cut the model your own way. It takes about 25 hours to print everything.

Tagi