Ant Poison Trap Holder

I designed this model while trying to deal with an ant infestation around my property. The ant bait discs I was using were constantly being blown away or stolen by squirrels and chipmunks. I was also concerned about the potential for wildlife to get into the bait, so I wanted to come up with a solution that would keep the bait in place and make it less accessible.

The container includes a separate helical ground screw that can easily be installed by hand using a common Phillips screwdriver. Once screwed into the ground, the container is surprisingly difficult to pull out, provided the soil isn't too sandy or soft.

For softer or sandier soil, I also designed a longer 110 mm helical screw, which provides additional holding power. The shorter screw works well for normal soil conditions.

Since designing and installing these around my property, I've had no further issues. The squirrels and chipmunks that were previously stealing the bait on a daily basis haven't been able to get them anymore.

Printing recommendations:
I recommend PETG for better durability outdoors.
No supports are required, and two walls are sufficient for the container.
The model needs to be split to objects, you can then print all parts on their face. The screws can be printed with no supports whatsoever, even the 110mm one. Standing up on the base worked for me (printed more than 10 in both a prusa L and C1.
3MF file also included.