Braun Bikini Styler Wall Hook

A single open yoke on a small back plate. The trimmer's barrel drops through it and the wider head sits on the top face, so gravity does the work — the same principle as a wall-mounted razor holder.

Nothing is enclosed. There's no cup or floor to collect water and skin debris, and a cloth reaches every surface in seconds.

The arm tips turn in by about 1.2 mm as a backup. If your trimmer's shoulder is less pronounced than expected, the arms will grip the barrel instead of the head resting on them.

Fit

Sized for a 20 × 15 mm barrel. Measure yours at the point where it would sit in the yoke.

Dimensions

• Back plate 40 × 58 × 4 mm

• Yoke at 20–38 mm, inner opening 21 × 16 mm, 2.5 mm arms

• About 13 g in PETG

Printing

Print exactly as the STL is oriented, back face down on the bed, do not rotate. Every wall is then vertical, and the inward tips at the arm ends are tapered rather than square so they self-support.

Printing the tape surface against the build sheet also gives a flatter face than any printed top surface would. Use a smooth sheet rather than textured; texture reduces the real contact area for the adhesive.

• 0.2 mm layers, 4 perimeters, 5 top/bottom, 25 % gyroid

• No supports, no brim

• PETG recommended for a bathroom. PLA works but softens in a hot shower room.

Use 4 perimeters rather than fewer. The arms flex across the layer lines when the trimmer goes in, and at 0.45 mm line width four perimeters make the 2.5 mm arms fully solid, leaving no sparse infill for a crack to start in.

Mounting

One strip of adhesive mounting tape is plenty at this weight. Degrease the surface first.

Companion model

There's a matching pair of holders for the Silk-épil 9 body and head, built the same way — same open construction, same print orientation, same 4 mm plate: