1 / 2
Noritake VFD mount for Prusa MK3/S/S+ — zdjęcie 1
1 / 2

Noritake VFD mount for Prusa MK3/S/S+

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modified MK3S+ LCD cover to accept a Noritake CU20045 VFD display

Ocena
0 / 5
Polubienia
2
Pobrania
3
Wydruki
0
Wyświetlenia
59
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v2.0

This was tested on my MK3S+, but should fit all MK3 printers, and possibly others.

I had one of these Noritake "CU20045-UW5J" VFDs in my electronics junk bin, left over from a day job project. Noritake designed this display to be mechanically/electrically compatible with a 2004 style LCD, but capable of operating at much colder temperatures. Low temperature operation isn't a requirement for this printer application obviously, but it certainly looks cool.

The VFD is 1mm taller than the stock 2004 LCD, and has a protruding glass nipple that needs clearance, so some mechanical changes were needed.

You'll need:

  • A "Reprap Discount Smart Controller" style display with a 2004 LCD, the same type used for the stock MK3 display. This one is a MKS brand one taken from my 3D printer part scrap pile.

  • A Noritake CU20045-UW5J VFD display. These can be bought new on Mouser for entirely too much money.

  • Two M2.5 x 6 screws, these are optional but helped solve a rattle issue I had.

Instructions:

  • Carefully desolder the 2004 LCD from the display board, at the LCD, leaving the pin header attached to the display board.

  • Remove pins 15 and 16 from the pin header - these are used for the backlight for the stock LCD, and the VFD doesn't have these pin locations on the header. Heat up the solder joint on the display board and pull these pins out of the pin header, don't cut them off flush or anything.

  • Solder the new Noritake display onto the pin header.

  • Install the display assembly into the cover per Prusa's instructions

  • Use two M2.5 screws to secure the bottom of the VFD board in place.

Since the display board sits 1mm deeper inside the LCD cover, you'll have to shim your knob outward 1mm so it doesn't strike the cover when you push on the knob. A printable shim is included, but I just jammed a M3 lock washer into mine.

SCAD source files are included. Enjoy!

Tagi