1 / 9
MR60 Male and Female Connector Covers — zdjęcie 1
1 / 9

MR60 Male and Female Connector Covers

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Covers to protect and allow sealing of joins utilising MR60 connectors

Ocena
0 / 5
Polubienia
2
Pobrania
39
Wydruki
0
Wyświetlenia
205
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

Covers for MR60 connectors. After soldering cables smear 5 minute epoxy onto the soldered joins and the end of the connector. pull cable back and click connector into place. once dry, fill with regular epoxy.

The tpu ring provides a seal. Smear connector terminals with dielectric grease and smear tpu and both yellow plastic faces of the connectors with silicone grease. The purple arrows on the two images show the raised text and twin lines that need to be removed from the connectors - these easily scrape off with a sharp blade.

There is a risk of epoxy seeping into the female sockets as they have tiny holes in the bottom. The 5 minute epoxy helps prevent this as well as using the 3 Prong epoxy seep preventer part - smear this with dielectric or silicone grease and fully insert into the female MR60 connector before injecting the regular epoxy. 

I print the male and female covers 'upside down' with the small cable end on the bed of the printer, seems counterintuitive but it allows the section where the connector mates to be a perfect clean fit which is important to make a perfect seal with the 5 minute epoxy.