1 / 4
ISA to USB (Dual USB Varient) Bracket/Slot Cover — zdjęcie 1
1 / 4

ISA to USB (Dual USB Varient) Bracket/Slot Cover

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple ISA slot bracket/expansion slot cover for ISA to USB cards with dual USBs (2.X Boards)

Ocena
0 / 5
Polubienia
0
Pobrania
3
Wydruki
0
Wyświetlenia
13
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

This is one of my first models, I apologize if its quite the mess!

This is a simple bracket/expansion slot cover for V2.4 variant boards of the CH375 based USB to ISA cards you can find on AliExpress (May support v2.X as long as the USB positioning looks the same). This appears to be a newer variant of the design with a dual USB. One port providing data and the other providing only +5 Volt power.

I could not locate anyone else online who have publicly uploaded a cover to support this particularly variant of the design. So I took it upon myself during a very slow and boring night to see if i can scramble something together in FreeCAD.

It took a couple revisions and the design is very basic. However, I imagine it should be fine for most cases.

There is a small overhang if you lay the cover flat against the print bed for where you would screw it down into your case. Using PLA I did not need to enable supports but if you have issues with this drooping down during the print, enable supports. No brim should be required.

Feel free to remix and modify as needed!

Tagi