JeNo Pocket V2 (Pavo 20 Pro Conversion)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is only the parts that I used to convert my Pavo 20 Pro II from it's original cinewhoop form to freestyle form.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 354
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
This page is to better suit the JeNo Pocket V2 for the Pavo 20 Pro II Conversion.
Since the day it's launched, I've always kept this in mind. Because on thing that I surely know
the Pavo 20 Pro component had a lot of potential for freestyle.
I used the 16mm Deck Height & 25 Deg Cam angle with 4mm Diameter M2 Standoff.
It gives you enough room to fit all the Pavo 20 Pro component inside + DJI O4 either the Flywoo wide lens, O3 Lens Mod, or the O4 Wide V2.
I'm using the grommets from Pavo 20 Pro O4 Pro Canopy. The steel M2 nut in the bottom help to raise the board so it will be just fit enough for the back / USB connectors not to be sandwiched by the carbon plates.
There's an updated camera plates for the official O4 Wide from the original pages - but I designed my 3D print to accommodate the original Flywoo Wide lens for the O4 & the O4 Wide V2.
It's still giving the lens a protection that it needs without getting any the camera plates or props in-view.
I do not change anything from the frame. It is a straight to the point conversion.
Yes, even the capacitor & battery strap is still the same.
Shorten the original XT30 Pigtail cable. It's not mandatory - but I like to make things neat.
Seek out my tune for this conversion here:
TUNE