Almighty cake water fountain

 WARNING!!! : Before you print, please read everything, as this is dangerous to use without knowing what to do. Extra information might make you think I'm trying to make you wait and read, but this is for your safety and everyone else's.

This fountain has 3 tiers, this has a drinks bar with a 180° phone stand and a medication space, this fountain can hold only up to 15-20 psi of pressure as it might break or even explode, do not use this model with a full blast of water from the hose, this will need a 36mm hose adaptor, if your hose fits in perfectly keep it how you want,  if the water is to high and the model doesn't fit, check out the height extender file, this will raise it up, using PETG/PLA filament is the best choice to use to print this as it is water proof, please do submerge these plastic/PETG/PLA height extenders in water before use! Because of the plastic/PETG/PLA, they have very high buoyancy and will float if they don't have water inside them, please let the fill with water.

CRITICAL!!! : After the print, for extra safety for the 180° degree phone stand and the medication, please do put sponges on the edges of the top tier,(green storage apartment), and on the bottom of it, when you slot the door in you will see some gaps in there as the gaps go in but are not joined, they will be a guide to where you should put the sponges, DO NOT PUT SPONGES ON THE DOOR!!!!!, Using double sided tape works the best for sticking the sponges, please clean and wash the sponges after the use of the fountain as this could make bacteria and make mould. You will have to scale this down to fit the  printer bed and also the height extender file as it is too big to fit in a Bambu lab, etc. Have fun !!!!!😀