1 / 1
Roomba Bumper
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Does you Roomba get stuck on low ridges? With this bumper you lower the standard bumper to about 1cm. To install, just…
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 179
- Wydruki
- 0
- Wyświetlenia
- 1724
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 5)Remiksy (0)Kolekcje (37)Powiązane
Does you Roomba get stuck on low ridges? With this bumper you lower the standard bumper to about 1cm.
To install, just unscrew the bottom of the bumper, place this print and fasten with the same screws.
No supports needed, layer height 0.3mm
Category: Replacement Parts