M57 "Clacker" Upgraded Magnet Spacers P125BD-N52
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a spacer that goes in between magnets when replacing old M57 magnets with neodymium magnets.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 30
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a spacer that goes in between magnets when replacing old M57 magnets with neodymium magnets. Two are required. https://amazingmagnets.com/P125BD-N52-Neodymium-plate-block-magnet?srsltid=AfmBOoqNhbCS0AxN7aPyvzNGolZbbWOZ3OTaSHVS40JI2IILQvLBT6zm
@zebclayton6143
Thanks for the detailed video, I was able to restore one probably better than new by replacing the two bad magnets. Just wanted it to fire commonly available electric matches for fireworks displays. I disassembled as shown in the video. I verified both original magnets were installed north up, up being the button, before removal. I purchased the minimum qty 25 part number P125BD-N52 magnets from Amazing Magnets. These are the strongest you can get (N52), and 5 stacked up on each side is the same .625 as the originals but much, much more powerful. I verified continuity on the two output posts, and reassembled. I could not feel any voltage when holding the posts while clicking, but when I connected an electric match, it popped on the first snap. I also can connect an LED and it will illuminate brightly when snapped. I have enough magnets to fix one more, leaving 5 for the refrigerator.