C5 C5P Purge/Poop Auto Eject Remix with catch tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Creator 5 Poop Auto Eject. Remix of @KarolWalczak_52 "No more spaghetti Creator 5" model.
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 355
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Creator 5 / Creator 5 Pro Poop / Purge Auto Eject Remix.
Remix of @KarolWalczak_5200123 "No more spaghetti Creator 5" model. The design and fit of the original is great. The designer took some time to make sure the fit was good. All credit goes to original designer.
Remix changes:
1) moved the purge/poop platform towards the back of the printer, this centers the poop/purge a little better
2) made the outside corner a sharp corner rather than following the rounded edge of the build table. The square edge will help give a square push of the poop/purge off of the platform.
3) Changed magnets to 10mm x 3mm
4) Changed the fastener holes to accept 3mm bolts, and used a spring so can be used in heated chamber.
5) Cut a aluminum can to be used as a wiper.
Wiper template is included in .3mf
6) Added catch tray. There are 2 tabs that hold the tray in place under the printers back acrylic panel. You may need to file down these 2 tabs to get a nice snug fit.
Materials used:
QTY4, 10mm x 3mm magnets (alternate polarity for stronger magnetic attraction to heater plate).
QTY2 3mm fasteners
Spring, Extension - 0.5 mm wire, 6.3 mm OD (5.3 mm ID), 31 mm uncompressed
PTFE Heat resistant tape. Kapton or Aluminum tape can be substituted, but PTFE is very slippery
Your favorite beer can