PCCF Prusa Pulley with 608 Ball Bearing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed to add 608 ball bearing
- Ocena
- 4 / 5
- Polubienia
- 2
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 126
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Short Version
If you download and do a quick print you’ll probably be dissatisfied. 😡
Long Version
The wheel on the original model didn’t spin very well for me, and would bind more with bigger loads. My cord would slide over the wheel instead of turning the wheel. This remix replaces the wheel and shaft with no change to the original housing. It uses the same M4x30mm screw and M4 nut. It is intended to be printed with PC Blend Carbon Fiber (a.k.a. PCBCF or PCCF) and the model is only tested with that material.
Hardware:
608 style ball bearings. I used 608ZZ bearings but 608RS might be better.
M4 x 30mm hex head screw
M4 hex nut
Why “long version”??? I had tweaked the design with default print settings prior to making it super strong. The bearing was perfectly snug. Then I printed the same STL with more perimeter walls, lots more. This stronger print also shrunk more than before — so much so that the bearing could not be inserted. So, I went back to my design and dialed it in making this assumption about how it would be printed:
Print Parameters for Shaft, Wheel and Sleeve
0.4 nozzle
PC Blend Carbon Fiber
Seam location: random
0.20mm layer
no supports
20 perimeters <— this makes these 3 parts all perimeters, and “predictable” shrink.
(At least that is the idea :-)
Print Parameters for Housing
I looked at the gcode of the original. There are only 2 perimeter walls. That may be enough, but I added more.
5 perimeters
Some Assembly Required 😀
Screw the M4 x 30mm screw into the Shaft, then remove it.

Press the 608 bearing into the Wheel.


Press the Shaft into the bearing
Install the Sleeve onto the Shaft. This will require some tapping with a small mallet.


****** now continue with original assembly ******Push the Wheel/Bearing/Shaft/Sleeve assembly into the housing. It goes in and down. Line up the Shaft hole with the holes in the housing. This is not an easy push (like the original), but tools shouldn’t be needed.
Press the nut into the pocket on the housing.
Screw the M4 x 30mm screw through the housing and shaft, and into the nut. Tighten.
Use
The housing has been embossed with ↑UP↑ on the end that should be up when using the pulley vertically. In this orientation the shaft gets support from the “cradle” in the sides of the housing.
How Much Weight Is This Pulley Able To Lift??
I have no idea! But I can say that my cord turns the wheel of this pulley 👍 and it works great😎 lifting small loads!
Maybe an ambitious Maker🤩🤩 will do some testing💪, and show some photos of failures!⛓💥
I hope you enjoy the model! Comments📝, likes❤, ratings🤩 encouraged!