PRINT IN PLACE BOXER-4 FIDGET
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
not quite print in place but close enough
- Ocena
- 5 / 5
- Polubienia
- 20
- Pobrania
- 67
- Wydruki
- 1
- Wyświetlenia
- 382
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Almost completely print in place, the gear press fits onto one of the ends of the camshaft making the design ambidextrous as well. A keychain loop could be installed on one of the holes in the corners.
Print the engine at at least 15% infill, at least 3 walls, supports on, and make sure you have tons of bed adhesion because the first 20 layers are prone to snapping off. Gear can be printed flat face down, no supports, whatever settings you want. Remember to remove at least most of the supports before press fitting the gear on and giving it a spin because if there is a piece of plastic lodged in the shaft somewhere it could twist itself pretty bad.