JST - XH (2.54mm) crimp plug pin terminal extractor / remover / removal tool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tools to un-make JST-XH plugs to salvage the shells
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 254
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This little set of tools is to release the crimp-on terminals from JST-XH (2.54mm) plugs so the shells can be reused. To use, push the cable as far foward in the plug body as it will go, then squeeze the tool down tight over the release holes in the plug and wiggle the wires to get them to release.
This is a precision part so it's going to depend a lot on the accuracy of your printer to make it work. This is best printed using a small nozzle size, 0.4mm will work, 0.25mm or smaller will be better. 0.5mm or larger will NOT work. If your slicer has a "Precise wall" and/or "Precise Z" option then use them!
These tools are designed for use with name-brand JST connectors, no-name and look-alikes are often subtly out-of-spec which means the tool won't quite fit. I've provided the .SCAD so you can tweak them as needed to get them to fit your connectors.