Heavy-Duty 25mm Side Release Buckle for Backpacks & Straps (No Supports)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small replacement buckle for backpack
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 85
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have designed this buckle to replace the one from my personal backpack. It should be precise enough to be used without post processing and without having any play. It's surprisingly strong, i haven't been able to open it by pulling on both ends despite not being difficult to open in the correct way. It prints easily without support, it's designed to be printed on the flat side to have the layer lines in the optimal orientation. Thanks to the small teeth it doesn't slip under normal forces but can still be adjusted and does not bite aggressively ruining the straps. i have printed it in PLA but i think it would work better in PETG. I have made it for my backpack with 25mm straps, the openings are exactly 25mm but works in the same way also on smaller straps.