1 / 3
Fingercopter (0.18g) Micro Flying Toy (0.18g) — zdjęcie 1
1 / 3

Fingercopter (0.18g) Micro Flying Toy (0.18g)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Weighs just 0.18g! Spin it in your fingers to watch it fly. Super fast, zero-waste print using filament scraps.

Ocena
0 / 5
Polubienia
15
Pobrania
88
Wydruki
0
Wyświetlenia
326
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — NoDerivatives

📝 Model Description

Meet the Fingercopter, an ultra-lightweight, high-performance micro flying toy designed to launch straight from your fingertips! Weighing a mere 0.18 grams, this miniature propeller is optimized for maximum lift and aerodynamic efficiency with minimal mass.

Simply roll the stem rapidly between your thumb and index finger, release, and watch it soar across the room. It is the ultimate "filament scrap bender" project, a fun desk toy, and a fantastic conversation starter for school classrooms or maker spaces.

🛠 Features & Advantages

  • Featherweight Flight: Optimized blade geometry allows a 0.18g frame to catch the air effortlessly.

  • Instant Print: Takes only a minute or two to print, making it perfect for using up the last few centimeters of a filament spool.

  • Zero Waste: No supports, no rafts, and no assembly required.

  • Great Calibration Test: Serves as an excellent real-world benchmark for first-layer adhesion, retraction, and cooling on thin geometries.

🖨 Recommended Print Settings

Because this model is incredibly small and delicate, precise settings are key to flight performance:

  • Material: PLA or lightweight PETG (PLA is recommended for stiffness).

  • Layer Height: 0.12mm or 0.16mm (thinner layers keep the blades aerodynamic).

  • Infill / Perimeters: 100% infill (at this scale, it will print completely solid anyway).

  • Cooling Fan: 100% (critical to prevent the tiny stem from melting during printing).

  • Bed Adhesion: Ensure your bed is perfectly leveled and clean. A brim is usually not needed, but add a 1-2mm brim if you struggle with small part adhesion.

🚀 Flight Tip

For the best launch, grip the lower half of the stem, rub your hands together quickly (like starting a fire with a stick), and flick it upward smoothly.


Tagi