Bathroom organizer for manicure tools + SEYSOO toothbrush holder

A practical stepped organizer designed for everyday bathroom and manicure tools + SEYSOO toothbrush holder.

It keeps scissors, tweezers, nail clippers, files, cuticle tools, floss picks and other small accessories visible and easy to reach. The front tray provides space for toothpaste and loose items, while the removable insert securely holds two SEYSSO electric toothbrushes.

Features

• Stepped construction for good visibility and easy access

• Multiple slot sizes for different bathroom and manicure tools

• Removable upper stabilizing bridge for long tweezers, files and similar tools

• Matching upper and lower slots keep tall tools upright

• Removable press-fit insert for two SEYSSO toothbrushes

• Full rounded Ø8.20–7.65 mm toothbrush locating pins

• Open hollow layout that is easy to wipe and clean

• Separate accessories can be removed whenever they are not needed

The toothbrush insert is only a mechanical holder — it does not charge the toothbrushes.

Dimensions

Main organizer:

• 240 × 112 × 80.7 mm

Upper stabilizing bridge:

• approximately 233 × 31 × 35 mm

SEYSSO insert:

• 100 mm wide

• two holders spaced 50 mm apart

• 10 mm high locating pins

• designed as a firm press fit in the front tray

Recommended print settings

Material:

• PETG recommended for bathroom use

• PLA should also work, but PETG is more resistant to moisture and temperature

Main organizer:

• 0.20 mm layer height

• 3–4 walls

• 10–15% infill

• Gyroid or Adaptive Cubic infill

• Print with the large flat base on the build plate

• Supports recommended under the horizontal shelves

• A 3–5 mm brim may help with the long footprint

Upper stabilizing bridge:

• Print upside down, with the perforated shelf flat on the build plate

• No supports required

• 3–4 walls

• 15% infill

SEYSSO toothbrush insert:

• Print flat, with the locating pins pointing upward

• No supports required

• 3–4 walls

• 15% infill

Assembly

Place the upper stabilizing bridge on the middle shelf and align its slots with the slots below. The two legs rest at the outer ends of the shelf. Use white silicone or glue to fix it tightly if you don't intend to remove it, otherwise it might be a bit loose.

Press the SEYSSO insert evenly into the front tray. The fit is intentionally firm, so push both ends down gradually instead of forcing one side first.

Fit may vary slightly depending on filament shrinkage and printer calibration. Test the toothbrushes gently before pressing them fully onto the pins.

Designed and tested with SEYSSO electric toothbrush handles. Compatibility with other brands has not been verified.