Woom 2 Push Bar Mount

Compatibility / Important Note

This mount was designed and tested specifically for the Woom GO 2.

I’m not sure whether the frame dimensions are identical across different production years or between different Woom models. Therefore, I cannot guarantee that this mount will fit older or different versions of the Woom GO 2, or other models such as the Woom 2. Please compare the dimensions of your bike’s frame and the mounting points with the model before printing.

Use caution when using this mount. 3D-printed parts can break or fail unexpectedly, especially under high loads or repeated stress.

Accessories / What You Need

• 5 × M5 × 35 mm hex socket screws

• 5 × M5 nuts

• 5 × M5 washers (optional)

• 1 × M8 × 70 mm bolt (Pin needs)

• 1 × M8 nut

• 1 × 6 × 6 × 119 (leave tolerance) mm metal rod for reinforcement inside the printed part

Alternative: Instead of using a metal rod, you can set the internal cavity to 100% infill in your slicer before printing. However, I have not tested this option, so I cannot tell if it will provide enough strength.

Print Settings

I printed all parts using PETG with a 0.25 mm structural layer height. Print the parts as oriented in the provided files.

I increased the nozzle temperature by 10 °C from the default temperature to achieve maximum strength. This is because I use an HF (High Flow) nozzle.

Bottom

• Infill: 30% Gyroid

• Perimeters: 4

• Supports: None

Pin

• Infill: 100%

• Perimeters: 4

• Supports: Snug

Top

• Infill: 100%

• Perimeters: 4

• Supports: Organic

• Support placement: Build plate only

• If using the metal rod: Pause the print at 22.45 mm height and insert the metal rod into the internal cavity. Continue the print after inserting the rod.

Important: Check that 22.45 mm is the correct pause height for your printer and slicer before printing.