Flipsky 5085 motor with Foildrive Assist Max
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Motor cone, 3 blade prop hub and MR60 connector for flipsky 5085 motor for Foildrive Max. Onelock carbon mast version.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 21
- Wydruki
- 0
- Wyświetlenia
- 121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Components to attach a smaller motor to FoilDrive Assist Max units.
WHY: The smaller diameter 5085 motor has less power than the 6384 HP motor that FoilDrive provides. The smaller diameter makes it better suited for wing and parawing foiling due to the reduced weight (-400g) and the reduced resistance when re-entering the water on touchdowns.
To accomplish this, you need to get the Flipsky waterproof 5085 motor with a short shaft from their website or Ali. In addition you need the following parts provided here: 1. The motor cone to attach to your mast; 2. The motor hub to install the foildrive prop blades; 3. The MR60 connector to plug into your foildrive unit.
Some tips on printing. The cone can be printed in PETG with 10-15 wall loops and 25% gyroid infill. It takes a single beefy zip tie. Thread the ziptie before you use a long reach, ball end hex handle to screw down the 4 bolts to the motor. When installing on the mast, you can apply small segments of thin double sided tape to ensure that the cone does not move up and down before you tighten the zip tie.
The motor hub requires special attention so it does not break up when in use and cause you to lose your prop blades. Print it in SUNLU Easy PA, using CF or GF filaments generally will reduce layer adhesion causing failure. Make sure you dry the PA filament at 85C for 12-17hrs before the print. Otherwise moisture will turn into bubbles in the object. Use a soldering iron to install heat inserts for the prop blade screws.
The MR60 connector is needed to attach to the FD Max main unit. Cut motor cables to the desired length and feed through the back of the connector. Solder to the MR60 connector paying attention to the correct orientation, also test the motor without blades to ensure it rotates in the correct direction. If not, you just need to swap any two of the correct wires. Once everything is done, push the connector into the housing until it is fully seated against the back stop. Use the top hole to fill it with silicone or non-conductive TPU.