1 / 2
Brush Motor BeltMount 1B T104788 Fits Dyson's Ball Vacuum — zdjęcie 1
1 / 2

Brush Motor BeltMount 1B T104788 Fits Dyson's Ball Vacuum

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is the mounting piece that fastens the motor to the belt drive system in the rotating brush assembly.

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
17
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

The mount for the rotating brush assembly in my Ball Animal 1 broke and I couldn't find anyone selling it, so I recreated it using the broken part. I believe the part number is "1B T104788", at least that's what was stamped on the old broken part I removed. I recommend printing this with PETG with at least 15% infill. You really need to clean the part up with a box knife so it slides into the rest of the motor assembly. I also recommend that you put white lithium grease in the slides and the square contact point on the end that bumps up against the assembly holding the belt. From what I understand the ball 1, 2, and 3 all use the same motor assembly as well as a few other vacuums in the line. In the case that the part is close but not quite what you are looking for I included the step file along with the .3mf. 

Tagi