1 / 6
Sugar Skull Box — Calavera Trinket Box (2 Parts, No Supports) — zdjęcie 1
1 / 6

Sugar Skull Box — Calavera Trinket Box (2 Parts, No Supports)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Day-of-the-Dead calavera trinket box that splits at the brow — the cranium lifts off as a lid.

Ocena
0 / 5
Polubienia
5
Pobrania
6
Wydruki
0
Wyświetlenia
43
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution

A Day-of-the-Dead calavera trinket box. It splits across the brow: the cranium lifts off as a lid, the face stays on the base and holds a ~37 cm3 cavity — big enough for rings, guitar picks, dice or a folded note.

Closed size: 62 x 58 x 74 mm. Two printed parts, no hardware, no supports.

What's in this listing

  • Base — face + jaw, the cavity and the lid bore. Prints chin-down.

  • Lid — cranium cap, carries the brow art and the lip. Prints dome-up.

  • Inlay base / inlay lid — optional second-colour fills for the art.

  • SCAD — parametric OpenSCAD source.

Single colour? Print just base + lid; the art still reads as a 1.2-3.0 mm engraving.

How it closes

The lid's lip ring plugs 5 mm into a bore inside the base mouth — a slip fit on 0.12 mm radial clearance, seated by the lid's own weight. No interference: the seam is ~190 mm around, and a press fit over that length is unpullable.

Two-colour (AMS)

Each host and its inlay are coordinate-locked. Import both files of a pair in ONE dialog and answer Yes to "load as a single object with multiple parts". Do not use Split to Parts — it loses the pairing.

Print settings

  • Base — chin flat on the bed, mouth up. No supports, no brim.

  • Lid — closed pose, dome up, lip on the bed. Use a BRIM: its only bed contact is a 259 mm2 lip loop over a 190 mm perimeter, so it has little grip.

  • Slow the lid's overhang perimeters — the 621 mm2 seam annulus starts in mid-air.

  • 0.2 mm layers, 3 walls, 15% infill, PLA or PETG.

Walls are 3.2 mm; the 3.0 mm eye sockets get a boss behind them, leaving 1.5 mm of skin. Zero sub-45 degree overhang in either pose.

License: Creative Commons — Attribution.

Tagi