Voron Waveshare OV5640 Camera Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for OV5640 for Voron 2.4, Trident or any other 2020 CoreXY printer.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 55
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a camera mount for the Waveshare OV5640, adapted from Voxel3D_NL's HappyCam.
Motivation
I preferred to put a chamber light strip on the inside edge of the 2020 extrusion, so I wanted the camera to mount beneath the extrusion instead. Additionally, HappyCam has the camera upside-down which means you need to fix the orientation in software. Mainsail has this built in, but Home Assistant does not.
BOM
3x M3x8 BHCS
Print Notes
Print the housing with the screw holes down, no supports.
Print the door face down, with supports under the tab
Print the extrusion key with the chamfer side down
Assembly
Press the extrusion key into the slot on the housing
Attach the housing to the printer with 2x M3x8 BHCS
Connect the cable to the camera
Slide the camera in from the end and push down so the hole in the PCB seats on the pegs
Slide the tab of the door into the housing and press it flush with the housing body. It should press down on the camera PCB. Secure with 1x M3x8 BHCS