Monk pangolin — meditating pangolin figurine with mala beads
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A pangolin sat in meditation: prayer hands, a string of mala beads, a robe with a tassel and the tail curled round the…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 15
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
A pangolin sat in meditation — prayer hands, a string of mala beads, a robe with a tassel, and the tail curled round the base.
30 x 30 x 50 mm. One part, one colour, no assembly.
Printing
It prints upright, exactly as exported. The base is flat at z = 0, so it needs no raft and no brim.
Supports ARE needed: the underside of the snout and chin, the cavity behind the prayer hands, and the underside of the tail curl all overhang past 45 degrees. Tree / organic supports on build plate + everywhere, and keep them off the face if your slicer lets you paint them.
At 50 mm tall the scales are the part that carries the model, so print it fine: 0.12 mm layer height reads the individual scales clearly, 0.2 mm still reads as texture but softens the beads. 3 walls, 10 to 15 percent infill, around 15 to 20 g of filament.
A matte or silk filament flatters the scale relief far more than gloss. The photo is dark green PLA at 0.2 mm.
Scaling
It takes scaling up well — at 150 percent (75 mm) the mala beads and the tassel become properly legible. Below about 80 percent the beads start to merge together.
The mesh is a single watertight body, so it slices without repair.