Heart-shaped ring box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An engagement ring box with print-in-place hinges and a stop-to-add magnets.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 90
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution
This is heart-shaped box for an ring such as an engagement ring.
The fusion 360 file is included if you need to adjust the width of the slit for holding a thinner or thicker ring. I intentionally printed mine a little big so I could glue a little rubber in there to add grip and keep the ring in place.
Print information:
I printed at 0.2mm layer height. No supports required. Add a "pause print" at 9.40 mm to add 2 6x2mm magnets to each side. Make sure to get the polarity correct so that they attract to close the box not repel. I used a little superglue to hold them in the holes so that they didn't attract to the print header once the printer restarts.
Magnets I used are available on amazon.