Wristwatch Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a stand to place my wristwatches. I liked the one that came with a Casio so I designed a similar one.
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 96
- Wydruki
- 1
- Wyświetlenia
- 463
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
EDIT (08/12/2022): Added an improved version of the base with blind hole to facilitate the gluing of the assembly.
It holds wristwatches with a wrist circumference of about 22cm without a problem.
If you have heavy wristwatches (mine are not very expensive) you may want to put some weight at the bottom.
Print Settings
The whole design can be mirrored at will.
Printed in PLA, at 0.2mm resolution and 15% infill.
The top part should be on its side with supports.
The base can be printed as it is.
Assembly
The upper part fits into the base, which then can be glued in to place.
GIF of the assembly process:
