OPD Cart Label Upgrade-Fixes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Changes that I tried previously and wanted to either fix or remake cause boredom and wanted to.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 16
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Changes that I tried previously and wanted to either fix or remake cause boredom and wanted to. (Just wanted to try them in a new cad suite)
Tape Separator
Just a thin separator that hook around the front and keep the rolls from rolling the others.
Actually goes around it properly this time...
Rod Clips
Clip to keep the rod from bouncing out, makes the previous one actually stay in place.
Sticker Separator
Cause I hate having the slots without the defining feature of them, actually removing the sticker
Both normal and inverted are in the set/photos. The inverse causes the cart to roll the least while having less control while the normal one is the most controlled one.
Normal dispenses stickers towards the round bar and starts in the bottom slot.
Inverse dispense towards the tape cutter and start at the top.
Required Hardware
Double sided tape, preferably 3M, used the 0.5"×18ft 5925 tape in particular.
Optional Hardware | Seems like the slot is enough
4x M4 spring set screw, set to barely have tension on a blank backing.
.... Sticker Cutter ....
Likely a failure, uses either paste like blue tack or thin tape to adhere.
Only one properly fit, all the other ones were bent to heck.