Concrete cast survey marker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Casting mold to mark property markers permanently
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 33
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- GNU General Public License v3.0
This 3D Printed mold designed to cast another material, and in my case I use ultra hard cement, link below. Be sure to use a "release agent" to allow this form to separate from the cement once hardened. If you don't have a release agent, you may be able to try WD-40. Since this is a cast, the text is mirror reverse. You will need to print 1 lid, 3 mold wall sides, and 3 locking mechanism / clips. Everything snaps together, spray release agent, pour your concrete, wait to dry. Disassemble. I have reused these numerous times. Check the laws in your state - in my state you cannot make up your own property marker (you must be licensed) but you can point to an official existing marker. In my case a pin was buried in the ground and difficult to find. once found I simply placed this on top of the survey marker pin, such that this would not interfere with lawn mowing. Rapid Set Mortar Mix,
or similar, works perfectly. Large aggregate does not work well.