ST16 remote stick/gimbal guard/protector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
So I was afraid to whack my sticks on the remote everytime I put them down in the foam case of the Typhoon H so I…
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 222
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
So I was afraid to whack my sticks on the remote everytime I put them down in the foam case of the Typhoon H so I designed these to fit snuggly and protect them. Also good if you need to make a RMA and send them by mail (yes, I have done that)...
I tried to design them to look a bit like RC engines for multirotors with the airholes at the top, also added a yuneec text on the top part!
Print Settings
Printer:
RepRapPro Mendel
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0,2
Infill:
20
Notes:
Just print them with the large area down, no supports should be needed and change the resolution as you feel fit!
Post-Printing =============
Grinding
Not sure if it's just my printer but I had to remove a tad of elefant foot to get them to fit as I wanted.
Category: R/C Vehicles