Reprappro Mendel hotend and Autolevel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I got tired of trying to get my printbed level on my Mono mendel from ReprapPro so I started watching some guides on…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 4
- Wydruki
- 0
- Wyświetlenia
- 124
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I got tired of trying to get my printbed level on my Mono mendel from ReprapPro so I started watching some guides on how to enable autoleveling. It seems that the best way is to use a capacitive sensor since it will work on everything and not just metal. They are also pretty cheap on Ebay http://goo.gl/eFjuBZ so it's a win win!
You can see the X and Y offset in the image above and that should make the setup a lot easier.
So far I only tested to print it in PLA and the fitting for the sensor is really good actually, now I just need to print it in ABS!
Instructions
Remember to use ABS since the hotend will be mounted on this and it will get to hot for PLA
Category: 3D Printer Parts