X-Shot MPP Flared Magwell
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Flared magwell attachment for the X-Shot MPP
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 155
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
Flared magwell attachment for the X-Shot MPP. Clicks directly into the existing magwell - no need to loosen screws or disassemble.
5 walls, 20% gyroid. Strongly recommend printing this in PLA+ 2.0, Tough PLA, PETG, or any material with good toughness and can resist flexing. Regular PLA can be installed, but may snap if you crash a mag into it at a sharp angle, and will be very difficult to remove without breaking. I use Sunlu PLA+ 2.0, have had no issues in long game days, and it can be consistently removed in one piece if done carefully.
Add a filament change at layer 25 to replicate the photo, and add fuzzy skin to the flat area surrounding the striations.