Pimax Crystal Super x Vive DAS or Quest 3 Ancillary Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Use your vive DAS or quest 3 strap with your pimax crystal super
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 109
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Virtual Reality
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
(If you find any of my models for sale online (ebay, amazon, etc) it is not me, i do not sell prints; especially not at those insane prices. They are all listed as non-commercial works. I do not have a patreon or kofi or any donation platform. These models are only listed here on printables, for free, for you to print or use a print service like PCBway or JLCPCB, or your friends.)
Use your quest 3 strap or vive DAS with the crystal super.
There is another vive das attachment model made by another user, but i wasnt able to print that one without issues from the support; the screws also didnt want to bite... so i made this one.
This design has a end-stop to prevent the headset from resting on your cheeks.
If your going to use the vive DAS, i suggest using a 200g-300g counterweight
Disassembly:
Remove the foam side pads on the pimax headstrap
Unplug the connector for the speakers
Remove the speaker wire up to the pivot point
Unscrew the philips for the pivot point
Remove the visual modual from the super
Remove the 3 screws for the side arm mounts
Remove the 4 screws along the bottom of the super for the front plate
Pry the front plate off
Remove the 2 screws for the side arm mounts
Pull the speaker wire through and tuck it into the mounting pocket
Assembly:
Reuse all hardware, repeat same process in reverse.
Printing:
Print flat with 3x perimeters and with build plate supports



