Prusa MK3 Z axis vibration damper
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a very simple, super fast to print z-axis vibration damper for the original Prusa MK3.
- Ocena
- 4,474 / 5
- Polubienia
- 179
- Pobrania
- 1170
- Wydruki
- 15
- Wyświetlenia
- 9368
- Oceny
- 19
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
This is a very simple, super fast to print z-axis vibration damper for the original Prusa MK3.
The Z-top parts for the MK3 are closed at the top. Still the hole for the z-rods on the top parts are much larger than the Z-rods: this is as per design and should allow the rods to wobble a bit. The general accepted advice is to give the z-rods some space to do so. Great, however on my MK3 at certain z-heights, the rods touch the z-top parts and generate a rattling noise.
Hence I quickly made a small damper that you can slide over the top of z-rods to avoid the vibration. The walls are very thin (only one perimeter) and still allow for a lot of room for the z-rods to wobble. The top of the damper is only 0,2 mm such that it does not touch the z-axis top part. Print this with TPU or TPE. The noise is gone and I do not see any effects on print quality.
Print instructions
Use TPE or TPU and print slow.