Type-2 EV Wall mount Downwards facing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wall mount for a EV Type-2 charging cable where cables is held in place by gravity
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 30
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple wall mount for a Type-2 cable. I was previously using one from pintables that I pushed up into the mount and it was held in place by a small clip, but over time in the warm weather the clip stopped holding the cable in and it would would fall to the floor.
I have been unable to find a wall mount that uses gravity to hold the cable in place so I have designed my own.
Mine is printed in PETG. It can be printed without supports.
Your EV cable is probably quite heavy, use good screws/ fixings to hold the mount to the wall.