Bed Level Guage for Longer LK4 with Melt Zone Extender Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Bed leveling helper for Longer LK4 to accommodate melt zone extenders
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is heavily based on the dimensions of the "Bed Leveling helper for Longer LK4" model by @hadolfov. Changes from original:
Remade in OnShape from scratch
Includes two different length probes to accommodate those with and without melt zone extenders
Adjusted the position of some screws
Eliminated the piece connecting the probe to the lever to get a tighter reading on the meter
The probe to meter ratio is now 1:10 so that 0.1mm of vertical probe movement is equal to 1mm of movement (or 1 small line) on the meter
Added a lip to the top limit of the meter to hang the lever on when not in use
I connected each of the pieces together with M2x6 screws and connected the bracket to the printer's hot end carriage with some M2x8s. You can use M2.5 screws for a tighter fit between the base and bracket / bracket and carriage but I do not recommend using anything bigger than M2 to connect the probe and lever. Adjust these recommendations as needed to compensate for your printer's tolerances.
If you want to make any adjustments, open the OnShape document, copy it to your own OnShape account (free), and change as needed.
I use this melt zone extender: https://www.amazon.com/dp/B0CGTSNFNJ