Femi 1050 3D — laser holder (OEM 10503D-174 replacement)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Femi 1050 3D miter saw: replacement laser holder for OEM 10503D-174. Fits the Ø8.9 x 20.2 mm module. No support.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 6
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
The laser holder on a Femi 1050 3D miter saw cracks, and then the laser line wanders or the module
drops out. This replaces OEM part 10503D-174, measured off the original with calipers.
It takes the OEM laser module (**Ø8.9 × 20.2 mm**, part 10503D-173) and bolts to the same two holes on
the blade-guard flange. Those holes are slots, like the original — that is how you aim the line:
slacken, slide sideways, tighten.
## Fitting it
1. Slide the laser in from the back. There is no axial stop, so you choose how far the nose sticks
out — flush is a good default, and it plugs the bore against sawdust.
2. Drive an M4 × 14 into the boss. It self-taps (Ø3.4 pilot, no nut, no insert) and presses
directly onto the laser body. Gently — do not crush the module.
3. Bolt it to the flange, power the laser, slide it until the line falls on your cut, tighten.
## Printing
- No support. Mounting face on the bed — the STL is already in that orientation.
- 0.6 mm nozzle, 0.30 mm layers, 3 walls: 20 min, 6.4 g.
- PLA is fine. The one in the photos is PLA, mounted and in service. A blade guard never gets near
PLA's ~60 °C softening point, so the load here is vibration, not heat. PETG works too, it just is
not needed.
- The seat is Ø9.3 for a Ø8.9 module on purpose: a bore tilted at 62° prints undersize, and Ø9.0
jammed the laser at half depth. Snug slide, and the screw does the holding. Check the fit on a test
piece if you print at 0.4.
## OpenSCAD source included
femi_laser_holder.scad is attached and self-contained. Change bore_front_d for your printer's hole
shrinkage, laser_d / laser_len for a different module, slot_pitch for different hole spacing.
Printed, mounted, laser realigned and working. Mesh is watertight and a single body.
CC BY-SA 4.0 — use it, sell prints of it, modify it. Credit soyuka, and publish modified
versions under the same licence so the next Femi owner gets your fix too.
Not affiliated with Femi. Part numbers are there so you can identify the part you are replacing.
Also on Cults3D: https://cults3d.com/en/3d-model/tool/femi-1050-3d-laser-holder-oem-10503d-174-replacement