Fast Food Sauce Holder

Behold: The Dual-Wield Sauce Engine 🍗✨

Last night, I reached my breaking point. I was tired of the "lap-balance" dance at the chicken shop — trying to juggle a box of nuggets, a drink, and a peeling sauce lid while hoping for the best. I decided my drink cup needed to start doing some of the heavy lifting.

I've redesigned the classic straw-mounted sauce holder to be a true universal powerhouse.

🟩 𝗛𝗢𝗪 𝗜𝗧 𝗠𝗢𝗨𝗡𝗧𝗦

The straw is the mount. Feed it up through the center port, slide the holder down until it settles on the lid, and you're done — the straw carries the load and keeps everything centered. There's nothing to clip onto the rim and nothing to stick to the cup, so it lifts straight off when you're finished. If the cup has a straw, it works.

🟩 𝗪𝗛𝗔𝗧'𝗦 𝗡𝗘𝗪 𝗜𝗡 𝗧𝗛𝗜𝗦 𝗩𝗘𝗥𝗦𝗜𝗢𝗡

▸ 𝗧𝗵𝗲 𝗕𝗶𝗴 𝗕𝗼𝗿𝗲 — Other designs fail the second you get a jumbo straw. This has a widened port to accommodate everything from standard sips to heavy-duty milkshake straws.

▸ 𝗗𝗼𝘂𝗯𝗹𝗲 𝗧𝗿𝗼𝘂𝗯𝗹𝗲 — It's built to house two sauces simultaneously. Because let's be honest: living life with only one dipping flavor is a choice no one should have to make.

▸ 𝗖𝘂𝘀𝘁𝗼𝗺 𝗦𝗽𝗲𝗰𝘀 — If your local chicken joint uses "non-standard" pods (extra deep, circular, etc.), just reach out. I'll tweak the CAD file for your specific needs and post the update here.

🟩 𝗣𝗥𝗜𝗡𝗧 𝗦𝗘𝗧𝗧𝗜𝗡𝗚𝗦

No supports required · 0.10mm layer height · 250/300 speed · 10% gyroid infill · 3 walls · PLA

Field-tested on the morning run — the gallery shots are straight off my center console.

I hope you find this useful — happy dipping!