Large Finger Hold Jig For Use With Router
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Finger hold jig to be used with a router utilizing a straight flush trim router bit for larger cutting boards.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 107
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Finger hold jig to be used with a router that has a flush trim bearing for larger cutting boards. Creates a finger hold approximately 6" wide at the base and .9" tall. Depth is dependent on router and router bit.
I wanted a bigger finger hold for my thick 1-7/8" cutting board so I made a simple jig that works with straight flush trim router bits that have the bearing near the top of the bit (or the side near the collet of the router).
You can clamp this directly by the tabs that overhang the bottom of the board. If you want more room to insure your hands or router doesn't bump into the clips you can leverage one end a wood scrap to the tab by clamping the other end further away and doing the same to the other side of the jig.
Small sight notch and sight circle in center to help line up with lines marked on your workpiece.
I printed in PETG, but PLA should work just fine. I used 5 wall loop with a 0.4 nozzle and 10% gyroid infill.
Be sure to clamp tight and be very careful when running the router.