Lip Brush Holder for Vaseline 50ml Jar Lid V2

A tiny snap-in holder that mounts inside the lid of a Vaseline 50 ml jar, so your lip brush always travels with the balm.

What you get

• Two-step insertion, numbered on the part itself: slide the handle into the closed-end pocket (1), then snap the brush end into the clip (2)

• Pocket (1) is closed at the far end, so the brush always seats at the same depth

• Clip (2) is a flexing bridge rather than a solid wall, so it holds a range of handle thicknesses with a firm click

• Holder size 47 x 10.4 x 14.1 mm

• Mounts with a strip of strong double-sided tape, no screws

Fit check

• Vaseline Original Protecting Jelly, 50 ml jar lid

• Tuned around a 46 mm silicone lip applicator with an 11 x 7 mm head, the type sold in cheap multi-packs as a silicone lip brush

• Slightly thicker or thinner handles still clip in — that is what the flexing bridge is for

• Wipe the inside of the lid clean and dry before taping

What is new in V2

• Pocket (1) is now closed at the far end instead of running straight through, so insertion depth is repeatable

• Clip (2) is now a bridge instead of a solid block, which adds spring and widens the range of brushes that fit

Print settings

FDM, PLA or PETG.

• 0.2 mm layers / 2 walls / 15% infill

• Tree supports on — the flexing bridge is printed over open space

• Bundled 3MF is a Bambu Studio project for the P1S with these settings

Support me

If this design was useful to you, you can buy me a coffee ☕

Need a different size?

STEP file is included alongside the STL and 3MF, and the full Onshape source is public: Onshape document

LICENSE: CC BY-NC