Modretro M64 Cooling Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I just received a Modretro M64 and I think its great :)
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 113
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update 21/08/26: Added BASE_10.stl. Made to go under the fan assisted parts (FAN_15, 25, 30) so more airflow flows under to feed the fan.
Update 20/08/26: Added FAN_30.stl. Made for a 25mm thick 120mm fan but gives you more ceiling room above the fan as I noticed some fans (looking at you A12x25) have fat rubber corner pads that only leave you with a millimeter of space. This version gives you an extra 5mm Woohoo!
...
I just received a Modretro M64 and I think its great :)
I especially like the overclocking modes and that makes the bottom of the console a bit toasty.
So I made a fan assisted stand where you can just pop your M64 on top.
I don't think its going to melt and I haven't recorded temps (so i have no numbers for you). I just wanted to make the console more comfy.
I have been powering the fan using a usb fan controller but I will be looking into something that utilises one of the spare usb-c ports on the back (of the M64) so it can be a bit more self contained.
Printed using basic & translucent pla, 0.2 layer height, 5% rectilinear and I would recommend either a outer brim or targetted brim ears on the pillars at the front and back.
May your eyes be golden and your goombas be flattened…
--PATREON & PATREON SHOP.
--https://www.patreon.com/3DFreeman
Thanks for your continued support :)