1 / 3
P-Hive Infinity Smart Monitoring Bracket KIT — zdjęcie 1
1 / 3

P-Hive Infinity Smart Monitoring Bracket KIT

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3D printable kit for P-Hive Infinity - Solar-powered ESP32 monitoring — mounts directly on their official hive support.

Ocena
0 / 5
Polubienia
2
Pobrania
0
Wydruki
0
Wyświetlenia
180
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Public Domain

P-Hive Infinity Smart Monitoring Kit

This project extends P-Hive's official Infinity beehive support with a printable upgrade for hive monitoring (All parts are designed for permanent outdoor use and should be 3D printed in light color PETG, ABS or ASA filament for proper UV and weather resistance). The original P-Hive part is modified with an added mounting boss featuring threaded holes, allowing a custom electronics box to be securely screwed on (3D-printable M5 screws are included, and can be tightened using a Swiss Army knife, but standard M5 hardware works just as well). This box houses the full monitoring setup: a solar LiPo battery charger, a rechargeable LiPo battery, and an ESP32 microcontroller reading temperature and humidity via a BME280 or AHT21 sensor. A matching solar panel mount completes the kit (in this case, Solar cells dimensions are 160mm x 110mm) , together, these three parts turn a standard Infinity hive into a self-powered, connected hive, at low budget — giving beekeepers remote insight into their colony's conditions without any modification to P-Hive's original design. This kit could be an option available in the P-Hive spare parts catalog as a finished product or a DIY kit.

Could be associated with P-Hive Landing Board with Integrated Cable Pass-Through for Smart Sensors, to avoid drilling into the hive body.

The possibilities here are pretty much endless — plenty of makers have published their own beehive monitoring builds online, using different boards (ESP32, raspberry pi zero...), sensors, and power setups. That said, for a low-power, budget-friendly setup, the combo that comes up again and again (and for good reason) is: an ESP32 microcontroller paired with a BME280 or AHT21 sensor for temperature and humidity, powered by a small solar panel and battery. It's cheap, easy to source, sips very little power (especially with deep sleep enabled), and has WiFi built right in for sending data wherever you want. And it is evolutive, the weight analysis could be added with load cells integrated in the bracket for example, for a complete datas monitoring.

If you'd like more specific, step-by-step guidance for your own build, feel free to reach out — or ask an AI assistant to walk you through it.

Tagi