Rugged Grab Handle - Roof Top Tent
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Grab handle for T-Slot Rails or other mounting options.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 147
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
A printable replacement for the stock grab handle that bolts to the t-slot side rail of a rooftop tent. Modeled from measurements taken off the original part, printed in ABS-GF and ASA.
Fits any T-slot rail with the right bolt spacing.
Specs
Overall length 174.4 mm
Standoff from rail 44.2 mm
Height 25.0 mm
Knuckle clearance 20.2 mm
Bolt spacing 143.0 mm
~60g in ASA at 50% infill*
There's no back edge as the rail closes the opening. The bolt head sits inside the outboard cutout on each flare, so nothing protrudes past the outer face and there's no counterbore.
Hardware
2x M8 button head, ISO 7380 (5 mm hex key) - length to suit your rail
2x drop-in slide nuts for your rail channel
Printing
Print flat on the bed, as oriented in the file. Do not print on edge or standing up - layers stack in Z so load on the grip bar runs in-plane instead of peeling along layer lines.
No supports. Every cutout is a vertical prism; the only horizontal voids are the ~5.5 mm bolt hole and the key window, which is elliptical so there's no straight span to bridge.
Recommended to print in ABS or ASA which holds up better in sun.
* For load-bearing use: 6 wall loops, 50% gyroid infill. PA12-CF (Nylon) provides best results.